HP StorageWorks Enterprise File Services WAN Accelerator - Manual (Page 52)

52 C ONFIGURING THE HP EFS WAN A CCELERATOR
Setting Host Parameters
This section describes how to set host parameters for the HP EFS WAN Accelerator.
It includes the following sections:
‹ “Setting the Primary Interface,” next
‹ “Setting In-Path Interfaces” on page 54
‹ “Setting Auxiliary Interfaces” on page 58
‹ “Setting Main Static Routes” on page 59
‹ “Setting Static In-Path Routes” on page 60
‹ “Setting the DNS” on page 61
‹ “Modifying the Host Name” on page 63
‹ “Mapping Hosts to IP Addresses” on page 63
‹ “Setting Proxies” on page 64
Setting the
Primary
Interface You modify settings for the primary interface in the Host Settings - Interface Primary
page.
You were prompted to configure the primary interface when you completed the
installation wizard. This section describes how you can modify these settings.
IMPORTANT: The primary and in-path interfaces can share the same subnet. The primary and
auxiliary interfaces cannot share the same network subnet.