HP XP7 Storage - Manual (Page 111)

Description Error code
(SSB2)
The S-VOL is an BC Z volume. C3B7
An internal error occurred. C3B8
The specified S-VOL LUN is not defined; or the LUN includes a CU LDEV that is not supported by the primary
system. C3B9
A request for an Add Pair operation was rejected because of one of the following reasons: C3BA
The secondary system’s SSID or CU number is not supported.
Though the secondary system’s SSID or CU number is supported, the microcode of the main system device
does not support them.
The P-VOL is in online status. C3BD
These volumes cannot be specified as a Cnt Ac-S Z S-VOL: C3BE
BC Z S-VOL not in Suspended status
BC Z reserved volume
BC Z P-VOL in the process of reverse copy
A Cnt Ac-S Z S-VOL cannot be specified as an BC Z S-VOL, reserved volume, or P-VOL in the process of
reverse copy. C3BF
When the P-VOL is the BC Z S-VOL, the BC Z volumes should be a one to one combination. C3C0
A request for an Add Pair operation was rejected because the specified volume was already part of a Cnt
Ac-S Z or Cnt Ac-J Z pair (including journal volumes). C3C7
The S-VOL is reserved; or a secondary system, S-VOL, or the path between primary system and secondary
system is in the BUSY status. C3CA
The S-VOL is an BC Z volume. C3CD
The DKC type of the secondary system is not supported by Cnt Ac-S Z. C3D2
A pair cannot be created because the P-VOL is being used by Auto LUN. C3D4
The specified S-VOL is unavailable because the connecting port cannot recognize it. C3D6
The pair status of the S-VOL is invalid. C3D7
The pair cannot be created because the volume specified for the S-VOL is a system volume. C3D8
The pair cannot be created if the Cnt Ac-S Z S-VOL corresponds to any of the following: C3D9
The volume is a THP V-VOL; the pair using the volume is a BC Z pair or a Auto LUN reserve volume.
The volume is a THP V-VOL and an addition to volume capacity is in progress, or pages are being released.
The capacity of the volume is different from the capacity of the P-VOL
The volume is initialized by BC Z
The pair cannot be created because the volume specified for the P-VOL is a system volume. C3DA
S-VOL pair status is not Suspended or Suspended. C3DB
The required amount of shared memory for the operation is not installed in the secondary system. C4FC
Cnt Ac-S, Cnt Ac-S Z, Cnt Ac-J, and Cnt Ac-J Z cannot be mixed in the consistency group. CB12
The secondary system consistency group cannot be deleted because the Takeover command reversing
operations between the P-VOL and S-VOL failed. CB19
The secondary system consistency group was abnormally terminated because the Takeover command
reversing operations between the P-VOL and S-VOL failed. CB1A
No dummy volume can be created in the S-VOL. CB1D
Troubleshooting using RAID Manager 111