HP XP7 Storage - Manual (Page 69)

Note the following when viewing histories.
•
The Description column displays the operation that was run. The Descriptions are explained
in the following table.
•
“LDEV ID” indicates the XP7 physical LDEV ID, even when you use RAID Manager and use
pair volumes in a virtual storage machine.
Operation descriptions
The following table describes the operations shown in the Histories window.
Description Operation Displayed
A pair was defined. Pair definition
Creation of the pair was started. Paircreate Start
Creation of the pair was finished. Paircreate Complete
Restoring of the pair was started. Pairresync Start
Restoring of the pair was finished. Pairresync Complete
Splitting (Suspending) of the pair was started. Pairsplit-r Start
Splitting (Suspending) of the pair was finished. Pairsplit-r Complete
The pair was split (suspended) because of a failure. Pairsplit-r(Failure)
Release of the pair was started. Pairsplit-S Start
Release of the pair was finished. Pairsplit-S Complete
The status of the pair was changed from SMPL to COPY
because of an operation from the primary system. Status Change by MCU(SMPL to COPY)
The status of the pair was changed from SMPL to PAIR
because of an operation from the primary system. Status Change by MCU(SMPL to PAIR)
The status of the pair was changed from COPY to PAIR
because of an operation from the primary system. Status Change by MCU(COPY to PAIR)
The status of the pair was changed from COPY to PSUS
or PSUE because of an operation from the primary system. Status Change by MCU(COPY to PSUS/PSUE)
The status of the pair was changed from PAIR to PSUS or
PSUE because of an operation from the primary system. Status Change by MCU(PAIR to PSUS/PSUE)
The status of the pair was changed from PAIR to SMPL
because of an operation from the primary system. Status Change by MCU(PAIR to SMPL)
The status of the pair was changed from COPY to SMPL
because of an operation from the primary system. Status Change by MCU(COPY to SMPL)
The status of the pair was changed from PSUS or PSUE to
SMPL because of an operation from the primary system. Status Change by MCU(PSUS/PSUE to SMPL)
The status of the pair was changed from PSUS or PSUE to
COPY because of an operation from the primary system. Status Change by MCU(PSUS/PSUE to COPY)
The status of the pair was changed because an operation
for splitting a pair started at the secondary system. Status Change by RCU(Pairsplit-r Start)
The status of the pair was changed because an operation
for splitting a pair finished at the secondary system. Status Change by RCU(Pairsplit-r Complete)
An operation for releasing a pair has been started at the
secondary system. The status of the pair will change from
PSUS or PSUE to unpaired (SMPL). Status Change by RCU(PSUS/PSUE to SMPL; Pairsplit-S
Start)
Monitoring Cnt Ac-J operations history 69