HP 3PAR Operating System Software - Manual (Page 217)

Table 4 Quick Setup Steps for Unidirectional Pairs: 1-to-1, N-to-1, and 1-to-N Configurations
(continued)
Backup System Primary System Reference Step
Primary Volume Groups”
(page 74)
showrcopy 11. Verify synchronization.
Quick Setup: Bidirectional Remote Copy
Table 5 Quick Setup Steps for the Bidirectional Pair: 1-to-1, N-to-1, and 1-to-N Configurations
Backup System Primary System Reference Step
— — “Setting Up the Systems for
Bidirectional Remote Copy”
(page 77) 1. Verify that a
unidirectional Remote
Copy pair is already set
up.
— — “Verifying Virtual Volumes
Are Created for Remote
Copy” (page 71) 2. Verify that virtual volumes
exist.
creatercopygroup
<group_name>
<target_name>:<mode>
— “Creating Volume Groups
for Bidirectional Remote
Copy” (page 78) 3. Create primary volume
groups.
N-to-1: <mode> = periodic
setrcopygroup period
<period_value>s|m|h|d
— “ 4. (Optional, asynchronous
periodic mode only) Set
up automatic
synchronization.
<target_name>
<group_name>
admitrcopyvv
<VV_name>
— “ 5. Add the virtual volumes
to their volume groups.
<group_name>
<target_name:sec_VV_name>
— — “Deciding on an Initial
Replication Method”
(page 80) 6. Decide the method to use
for the first replication of
data.
— — “Using Tape for Initial
Synchronization and
Backup” (page 82) •
If using tape for data
transfer:
startrcopygroup
<group_name>
— “Starting Initial Replication:
Copying Data Directly from
Primary Volume Groups”
(page 80) •
If synchronizing directly
from system to system:
showrcopy — “ 7. Verify synchronization.
Quick Setup: Bidirectional Remote Copy 217