HP 3PAR Operating System Software - Manual (Page 231)

.
.
.
============================================================
TEST SUMMARY from 0:0:1 -> 10.100.18.164
Test Started: Wed Aug 10 10:34:15 PST 2011
Test Finished: Wed Aug 10 10:34:26 PST 2011
============================================================
Latency: 0.104 ms
Lost pings: 0 %
Through-put: 522 Mbits/second
Max MTU: 1500
Tx TCP Segs: 486675
Rx TCP Segs: 199271
TCP retrans: 0 %
Errored Segs: 0 %
Link 2:5:1 is SUITABLE for Remote Copy Use
SystemB# checkrclink stopserver
NOTES
•
Do not check the links if CPU usage is already close to 100%. The link check temporarily
increases CPU usage.
•
This test must be performed in two stages. To run a test between SystemA and SystemB:
Start the system on SystemB, specifying the <N:S:P> for SystemB and the <dest_addr>
for SystemA. a.
# checkrclink startserver <N:S:P> <dest_addr>
If you are running the checkrclink test on RCFC links, note the IP address displayed in the
output.
b. Start the client on the target system (SystemA), specifying the <N:S:P> for SystemA; the
<dest_addr>
for SystemB (as an IP address for both RCIP and RCFC links); and the
duration of the test in seconds.
# checkrclink startclient <N:S:P> <dest_addr> <time>
c. (Optional) To end the test before it completes, on SystemA enter:
# checkrclink stopclient
d. After the test is complete, on SystemB enter:
# checkrclink stopserver
231