HP 3PAR Operating System Software - Manual (Page 229)

In the following example, the admitrcopyvv command adds all volumes beginning with tpvv
to the primary volume group Group1. At the same time, it adds the secondary volumes, which are
named the same as the primary virtual volumes (as specified by @vvname@), on the target system
System2
to the corresponding secondary volume group (Group1.r<sys_ID>).
# admitrcopyvv -pat tpvv* Group1 System2:@vvname@
NOTES
•
A secondary volume mapping must be provided for each target in the group.
•
If a group’s target has the mirror_config policy set and the group is a primary group,
then this command is mirrored to that target and the volume is added to the secondary volume
group. If the policy is set and the group is a secondary, this command fails.
•
For multiple target Remote Copy groups, in addition to adding the primary/secondary mapping
on the target systems, the relevant mapping between the target systems will be added to the
backup groups.
•
For a list of virtual volumes that admitrcopyvv can admit to Remote Copy volume groups, see
“Rules for Forming Volume Groups” (page 191) .
229