Changing secondary volume groups to primary, Changing one volume group, Changing all volume groups on a system – HP 3PAR Operating System Software User Manual

Page 93

Advertising
background image

◦

<pattern>

- Pattern of volume group names (for example, Group*)

While this command completes, Remote Copy makes changes as a result of host writes only
on the primary volume (because the syncrcopy command sends the last resynchronization
points over the network to the backup storage system).

•

(Synchronous mode only) To manually force a full synchronization between volume groups in
synchronous mode:

# syncrcopy -ovrd <group_name>

or:

# syncrcopy -ovrd -pat <pattern>

◦

<pattern>

- Pattern of volume group names (for example, Group*)

•

(Asynchronous periodic mode) To schedule a resynchronization of an asynchronous periodic
volume group for a specific time (for example, 12:00pm each day), you must use a host-based
script that incorporates manual resynchronization commands.

For more information on the synchronization period, see

“Setting Up Resynchronization for

Asynchronous Periodic Mode” (page 201)

.

Changing Secondary Volume Groups to Primary

If a primary system or primary volume group fails, you can change secondary volume groups to
primary volume groups to aid in disaster recovery. This change:

•

Reverses the direction of data replication

•

Enables I/O to the volume groups

•

Allows you to export the volume groups as read/write as part of the disaster-recovery process
(if you do not change secondary volume groups to primary groups, volumes are exported as
read-only)

Changing One Volume Group

To change a single secondary volume group to a primary group, enter:

# setrcopygroup failover <group_name>

•

<group_name>

- Name of the secondary volume group (for example, Group1.r96) to change

to a primary group

Changing All Volume Groups on a System

To change all secondary volume groups on the backup system to primary groups, enter:

setrcopygroup failover -t <target_name>

•

<target_name>

- Name of the primary (failed) system (for example, System1)

Additional Information:

•

“About the Remote Copy Commands” (page 222)

•

“Recovering from Disaster” (page 102)

Changing Secondary Volume Groups to Primary

93

Advertising
This manual is related to the following products: