HP 3PAR Operating System Software - Manual (Page 269)

showrctransport
NAME
showrctransport -- The showrctransport command shows status and information about
end-to-end transport for Remote Copy in the system.
SYNTAX
showrctransport [options]
AUTHORITY
Any role in the system.
OPTIONS
-rcfc
Show information about Fibre Channel end-to-end transport.
-rcip
Show information about Ethernet end-to-end transport.
SPECIFIERS
None.
RESTRICTIONS
None.
EXAMPLES
The following example displays status and information about the end-to-end transport for all Remote
Copy configured ports:
# showrctransport
N:S:P Peer_Address Address State Type
0:5:1 - 172.100.5.87 new rcip
1:5:1 - 172.101.6.87 new rcip
The columns in the previous example are identified as follows:
•
N:S:P . The physical position of the port, in the syntax node:slot:port.
•
Peer_Address . IP address of the Remote Copy storage system port connected to this Remote
Copy port.
•
Address . IP address of the Remote Copy storage system port.
•
State . Remote copy end-to-end transport state. Can include one of the following results:
new . Configuration is not completed on this port. ◦
◦ incomplete . Configuration is not yet completed on the peer port.
◦ ready . Configuration is completed on this port and the peer port; transport is ready for
use.
◦ missing . A configured transport was disconnected.
•
Type . Indicates the port connection type.
rcip . Port is used for Remote Copy over IP (RCIP). ◦
◦ rcfc . Port is used for Remote Copy over FC (RCFC).
269