HP 3PAR Operating System Software - Manual (Page 264)

The columns in the previous example are identified as follows:
•
N:S:P . The physical position of the port, in the syntax node:slot:port.
•
State . State of the port.
ready . The port is online and ready for use. ◦
◦ loss_sync . The port is not physically connected to anything.
◦ config_wait . Firmware has yet to be initialized.
◦ login_wait . Fibre Channel adapter is attempting port and process logins with all loop
ports.
◦ error . Fibre Channel adapter has experienced an unrecoverable error.
◦ non_participate . Port is logically isolated from the Fibre Channel loop.
◦ offline . The port is offline.
•
HwAddr . A unique identifier of the port hardware used for Remote Copy connection. For an
RCIP port, it is the MAC address of the port.
•
IPAddr . The IP address of the Remote Copy interface.
•
Netmask . Netmask for the Ethernet port.
•
Gateway . Gateway address for the Remote Copy interface.
•
MTU . Maximum Transfer Unit (MTU) size for the specified Remote Copy interface (default is
1500). The largest supported value is 9000 and the smallest is 100.
•
Rate . Data transfer rate for the Remote Copy interface.
•
Duplex. Values can be either Full or Half.
•
AutoNeg . Autonegotiate.
NOTES
For full showport command information and additional usage examples, refer to the HP 3PAR
Inform OS CLI Reference.
264 The Remote Copy Commands