HP 3PAR Operating System Software - Manual (Page 214)

Quick Setup: RCIP Transport Layer
Table 2 Quick Setup Steps for RCIP
Backup System Primary System Reference Step
controlport rcip addr
[-f] <port_IP>
<netmask> <N:S:P>
controlport rcip
addr [-f] <port_IP>
<netmask> <N:S:P>
“Setting Up the Remote
Copy Interface for RCIP”
(page 33) 1. On all RCIP ports, set up
the interface.
showport -rc showport -rc “ 2. Verify IP addresses and
netmask.
controlport rcip gw
[-f] <gateway_IP>
<N:S:P>
controlport rcip gw
[-f] <gateway_IP>
<N:S:P>
“Setting the Gateway”
(page 34) 3. On all RCIP ports, set the
gateways.
showport -rcip showport -rcip “ 4. Verify gateway IPs.
controlport rcip ping
<target_IP_address>
<N:S:P>
controlport rcip
ping
<target_IP_address>
<N:S:P>
“Verifying the Servers Are
Connected” (page 35) 5. Verify connectivity.
a. checkrclink
startserver
<N:S:P>
<dest_addr>
“Checking Link Throughput
and Latency” (page 36) 6. On all nodes and
systems, check the links.
b. checkrclink
startclient
<N:S:P>
<dest_addr> <time>
c. checkrclink
stopserver <N:S:P>
controlport rcip mtu
9000 <N:S:P>
controlport rcip mtu
9000 <N:S:P>
“Increasing MTU (Optional)”
(page 37) 4. (If possible) On each
port, increase MTU.
controlport rcip ping
-s 8972 -pf
controlport rcip
ping -s 8972 -pf
“ 5. (If MTU increased) On
each port, verify MTU
support.
<target_IP_address>
<N:S:P>
<target_IP_address>
<N:S:P>
214 Quick Setup Guide