HP 3PAR Operating System Software - Manual (Page 280)

statrcvv
NAME
statrcvv -- The statrcvv command displays statistics for Remote Copy volumes in a timed
loop.
SYNTAX
statrcvv [options <arg>] [<VV_name>|<pattern>]...
AUTHORITY
Any role in the system.
OPTIONS
–d <secs>
Specifies the interval in seconds that statistics are sampled from using an integer from 1 through
2147483. If no count is specified, the command defaults to 2 seconds.
-iter <number>
Specifies that the statistics are to stop after the indicated number of iterations using an integer
from 1 through 2147483647.
-t <target_name>...|<pattern>...
Show only volumes whose group is copied to the specified target name or pattern. Multiple
target names or patterns may be specified using a comma-separated list.
-port <port_NSP>...|<pattern>...
Show only volumes that are copied over the specified port, expressed as <N:S:P>, or pattern.
Multiple ports or patterns may be specified using a comma-separated list.
-g <group_name>...|<pattern>...
Show only volumes whose group matches the specified group name or pattern. Multiple group
names or patterns may be specified using a comma-separated list.
-sync
Show only volumes that are being copied in synchronous mode.
-periodic
Show only volumes that are being copied in asynchronous periodic mode.
-primary
Show only volumes that are in the primary role.
-secondary
Show only volumes that are in the secondary role.
-targetsum
Displays the sums for all volumes of a target.
-portsum
Displays the sums for all volumes on a port.
-groupsum
Displays the sums for all volumes of a group.
-vvsum
Displays the sums for all targets and links of a volume.
-domainsum
Displays the sums for all volumes of a domain.
-domain <domainname>...|<pattern>...
Show only the virtual volumes that are in domains with names that match the specified domain
name(s) or domain name pattern(s).
280 The Remote Copy Commands