HP Deskjet 6940 - Manual (Page 37)

Configure Bluetooth settings
The method to configure Bluetooth settings for the printer depends on whether the printer
is connected to a network.
If your printer is not connected to a network
Note If your printer is not connected to a network, you will need a USB cable to
configure the Bluetooth settings.
1. Connect a USB cable from your computer to the rear USB port on the printer.
2. Open the printer Toolbox .
3. Click the Configure Bluetooth Settings tab.
4. Configure the settings you want, and then click Apply.
If your printer is connected by Ethernet cable to a network
1.
Open the printer's embedded Web server (EWS) .
2. Click the Bluetooth tab.
3. Configure the settings you want, and then click Apply.
The following table describes the Bluetooth settings:
Option Description
Device Address The MAC address of your Bluetooth wireless printer adapter.
Device Name The device name assigned to the printer so that other Bluetooth
devices can identify it.
Passkey The 4-digit number you must enter before you can print using
Bluetooth. The default passkey is 0000.
To change the Passkey
●
Toolbox: Click Change Passkey, and then enter a new 4-
digit number.
● EWS: Enter a new 4-digit number.
Reset Bluetooth To reset Bluetooth to factory default settings
●
Toolbox: Click Reset Device Access.
● EWS: Click Yes, reset Bluetooth.
Visibility To select the printer's visibility to other Bluetooth devices
●
Toolbox: Click the Make device visible to other
Bluetooth devices check box to allow any Bluetooth
device within range to discover and use the printer. If not
User's guide 35