HP Network Storage Router m2402 - Manual (Page 187)

Hardware Module Replacement
193 Network Storage Router M2402 User Guide
Installing the Fan Module
To install the fan module:
1. If a fan module has not been removed, see the preceding procedure,
“Removing the Fan Module” When completed, go to Step 2.
2. Remove the new fan module from its shipping container and remove all
packing material from around the module.
Caution: Place the module onto a smooth surface and avoid exposure to
direct sunlight, liquids or vapors, excessive heat, or risk of accidental dropping
or other damage.
3. Insert the new fan module into the fan bay, using the orientation shown in
Figure 115 , Installing a Fan Module. Push the module into position until the
fan latches lock into place.
Figure 115: Installing a fan module
4. Verify the newly installed fan module is functioning properly by viewing the
Environmental Statistics screen of the Serial/Telnet user interface or the
Report Screen of the Visual Manager user interface. These display screens
confirm that each fan in the module is rotating.