HP Network Storage Router m2402 - Manual (Page 31)

Installation
37 Network Storage Router M2402 User Guide
Installing the Router in a Rack
The following items in the router kit are used to rack-mount the router:
■ Mounting rails
■ Extender brackets
■ Bag of mounting hardware (8 #M6x12 Phillips screws, 4 #6-32x.312 Phillips
screws)
■ Bezel blank
Note: The installation process requires a #2 Phillips and a #2 flat-head screwdriver.
To install the router in the rack:
1. Remove the router from its protective bag.
Note: Before installing the router, make sure that all modules are properly installed.
For information about the removal or installation of modules, refer to Chapter 7,
“Hardware Module Replacement.”
Caution: Place the router onto a smooth surface away from any potential
exposure to direct sunlight, liquids or vapors, excessive heat, or risk of
accidental dropping or other damage.
2. Determine where the router will be installed, ensuring that the air-flow vents
remain clear of obstructions.
3. Separate the inner rail from the outer-rail assemblies (see Figure 14 ).
a. Place a thumb or finger over the circular grasping hole at the front-end of
the inner rail.
b. Extend the inner rail out from the outer-rail assembly until it locks into
place.
c. Press the spring-latch on the back of the inner rail to release the lock.
While holding down the spring-latch, extend the inner rail until the two
rails separate.