HP Network Storage Router m2402 - Manual (Page 75)

Visual Manager User Interface
81 Network Storage Router M2402 User Guide
Modules Menu tasks:
■ World Wide Node Name configuration changes World Wide Node Name.
■ Fibre Channel Module configuration changes FC module settings.
■ SCSI Module configuration changes SCSI module settings.
Each Modules Menu option is discussed in the following sub-sections.
World Wide Node Name Configuration
The World Wide Node (WWN) Name screen is used to change the WWN Name
settings for the router.
Figure 41 is an example of the World Wide Node Name
screen.
These WWN settings are not normally changed.
Caution: Changing the WWN Name could result in duplicate names on a
single Storage Area Network. HP recommends using the default values for
WWN.
Note: For Controller LUN commands to be operational, WWN naming schemes MUST
be compliant with IEEE Fibre Channel Format 1, where the left-most hexadecimal
character (the NAA field) of the WWN is '1'. The sixth hexadecimal value from the
right must be a value of '0' or'1'.
Note: If the configuration settings are reset to the factory default, these customized
WWN settings will be overwritten.
Figure 41: World Wide Node Name screen