HP Network Storage Router m2402 - Manual (Page 190)

Hardware Module Replacement
196 Network Storage Router M2402 User Guide
Installing an I/O Module or Blank Module
To install an I/O module:
1. If an I/O module or blank module has not been removed, see the preceding
procedure, “Removing an I/O Module or Blank Module” When completed,
proceed to Step 2.
2. Remove power to the router.
3. Remove the new I/O module from its shipping container and remove all
packing material from around the module.
Caution: Place the module onto a smooth surface and avoid exposure to
direct sunlight, liquids or vapors, excessive heat, or risk of accidental dropping
or other damage.
Figure 118 illustrates a SCSI module and Figure 119 illustrates a Fibre Channel
module.
Figure 118: Thumbscrews and handle on a SCSI module
1
2