HP Network Storage Router m2402 - Manual (Page 222)

Regulatory Compliance Notices
228 Network Storage Router M2402 User Guide
Power Cords
WARNING: This product can ONLY be used with an HP approved power
cord for your specific geographic region. Use of a non-HP approved power
cord may result in:
■
Not meeting individual country specific safety requirements;
■
Insufficient conductor ampacity that could result in overheating with
potential personal injury and/or property damage; and
■
An unapproved power cord could fracture resulting in the internal
contacts being exposed, which potentially could subject the user to a
shock hazard.
HP disclaims all liability in the event a non-HP approved power cord is used.
The power cord set included with this product meets the requirements for use in
the country where you purchased this product. If you need to use this product in
another country, you should purchase a power cord that is approved for use in that
country.
The power cord must be rated for the product and for the voltage and current
marked on the product’s electrical ratings label. The voltage and current rating of
the cord should be greater than the voltage and current rating marked on the
product. In addition, the cross sectional area of the wire must be a minimum of
1.00 mm² or 18AWG, and the length of the cord must be between 6 feet (1.8 m)
and 12 feet (3.6 m). If you have questions about the type of power cord to use,
contact your HP authorized service provider.
Note: A power cord should be routed so that it is not likely to be walked on or
pinched by items placed upon it or against it. Particular attention should be paid to the
plug, electrical outlet, and the point where the cord exits from the product.