HP Color LaserJet 4500 Printer series - Manual (Page 104)

104 Printer Interfaces
EN
Configuring the Printer for the Network
at the Printer Control Panel
You might need to configure certain network parameters on the
printer. You can configure these parameters from the printer control
panel or, for most networks, from the HP JetAdmin software (or the
HP LaserJet Utility for Macintosh). The utilities are provided on the
printing software CD-ROM that comes with the printer.
For a complete list of supported networks and for instructions on
configuring network parameters from software such as the
HP JetAdmin software, see the
HP JetDirect Print Server Software
Installation Guide. The guide comes with printers in which an
HP JetDirect print server is installed.
This section contains the following instructions for configuring
network parameters from the printer control panel:
● Configuring Novell NetWare Frame Type Parameters
● Configuring TCP/IP Parameters
● Configuring the Apple EtherTalk Phase Parameters
● Disabling Unused Network Protocols
Configuring Novell NetWare Frame Type
Parameters
The HP JetDirect print server automatically selects a NetWare frame
type. Select a frame type manually only when the print server selects
an incorrect frame type. To identify the frame type chosen by the
HP JetDirect print server, print a configuration page.