HP Color LaserJet 4500 Printer series - Manual (Page 106)

106 Printer Interfaces
EN
Configuring TCP/IP Parameters
To configure TCP/IP parameters, you can use the HP JetAdmin
software that is included on the printer’s software CD-ROM. If you
choose not to use this utility or are using a UNIX system other than
HP-UX, Solaris, or SunOS, you can use the printer control panel to
configure the following TCP/IP parameters:
● Usage of the BOOTP file for configuration parameters (the default
is to use the BOOTP file)
● IP address (4 bytes)
● Subnet mask (4 bytes)
● Default gateway (4 bytes)
● TCP connection timeout (in seconds)
Note Do not disable BOOTP if you will be using RARP or DHCP to configure
TCP/IP parameters.
To configure TCP/IP parameters from the printer
control panel
1 Press M ENU until HP EIO 1 MENU displays.
2 Press I TEM until CFG NETWORK=NO * displays.
3 Press V ALUE until CFG NETWORK=YES displays.
4 Press S ELECT once. CFG NETWORK=YES * displays.
5 Press I TEM until CFG TCP/IP=NO * displays.
6 Press V ALUE once. CFG TCP/IP=YES displays.
7 Press S ELECT once. CFG TCP/IP=YES * displays.
8 Press I TEM to configure TCP/IP parameters manually.
BOOTP=YES * displays.