HP OneView User Manual
Page 290
5.
In the details pane of the Logical Interconnect Groups screen, you can use your pointing device
to hover over an uplink set in the diagram to highlight the connections for that uplink set.
Actions
Overview
Enclosure 1 LIG
General
Logical Interconnect Group
V
V
V
V
Update logical-interconnect-groups Completed
Administrator
Today 5:32:10 pm
Used By
EncGrp1
Encl1-LI
Edit
vSphereUS
2 networks
2 uplink ports
1 network
2 uplink ports
proudUS
4 networks
2 uplink ports
2 uplink ports
FCUS1
FCUS2
1 network
X1 X2
HP VC FlexFabric 10Gb/24-Port Module
X3 X4 X5 X6 X7 X8
X1 X2 X3 X4 X5 X6 X7 X8
HP VC FlexFabric 10Gb/24-Port Module
1
2
1
2
3
4
1
2
3
4
HP VC 8Gb 20-Port FC Module
3
4
HP VC 8Gb 20-Port FC Module
A.5.4.2 Creating a logical interconnect group for enclosure 2
In this procedure, you will create a logical interconnect group for the second enclosure. It contains
an HP Virtual Connect FlexFabric-20/40 F8 Module.
NOTE:
See
“About the HP Virtual Connect FlexFabric–20/40 F8 interconnect module” (page
for important considerations in using this module.
Creating the logical interconnect group
1.
From the
, select Logical Interconnect Groups and click + Create logical interconnect
group.
The Create logical interconnect group dialog box opens. The large boxes on the screen
represent enclosure interconnect bays, with bays 1 and 2 in the top row, bays 3 and 4 in the
next row, and so forth. Only interconnects of the same model can be installed in horizontally
adjacent bays.
2.
For Name, enter Enclosure2LIG.
3.
In interconnect 1, click Add interconnect and select HP Virtual Connect FlexFabric 20/40 F8
Module.
4.
In interconnect 2, click Add interconnect and select HP Virtual Connect FlexFabric-20/40 F8
Module.
5.
Leave the dialog box open so that you can create the uplink sets.
Creating the uplink sets for the Fibre Channel networks
The uplink sets assign data center networks to physical interconnect ports.
1.
Click Add uplink set.
The Add uplink set dialog box opens.
2.
Configure the uplink set for the FC 3 Fibre Channel network:
a.
For Name, enter FCUS3.
b.
For Type, select Fibre Channel.
The dialog box expands to include additional configuration items.
c.
For Network, select FC 3.
3.
Configure the uplink ports:
a.
For Interconnect under Uplink Ports, select Interconnect: 1.
The appliance displays the ports that you can use for Fibre Channel networks.
b.
Select ports X3 and X4. Use the defaults displayed on the screen for Speed.
290 Step by step: Configuring an example data center using HP OneView