HP Hitachi Dynamic Link Manager Software - Manual (Page 355)

executing /opt/DynamicLinkManager/bin/dlnkmgr view -sys -
msrv), and then start it.
¢
Even if the HDLM manager is running, Dead might be displayed when
you execute /opt/DynamicLinkManager/bin/dlnkmgr view -sys -
msrv. If this happens, see
What To Do for the Program Error on page
5-7 .
Important
When stopping the HDLM manager, even if a message indicating that
the HDLM manager has successfully stopped, it takes a few seconds
more to stop processes. Therefore, if you start the HDLM manager
immediately after stopping it, the HDLM manager is regarded as being
started, and a message indicating that the HDLM manager has
successfully started is output. However, starting of the HDLM
manager is cancelled, and it will remain inactivate.
Use one of the following procedures to confirm that the HDLM manager is
active:
Use the dlnkmgr command's view operation:
Execute the following command:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -msrv
HDLM Manager Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
KAPL01001-I The HDLM command completed normally. operation name
= view, completion time = yyyy/mm/dd hh:mm:ss
#
When the HDLM Manager column shows Alive, the HDLM manager is
active.
Use a script for confirmation:
Execute the following command to confirm that the HDLM manager is
active:
# /etc/init.d/DLMManager status
.dlmmgr_exe (pid 14889 14886 14884 14880) is running...
Note
If an error occurs, the execution results of the dlnkmgr command's view
operation might be different from those of the DLMManager status
command. In this case, see the execution results of the dlnkmgr
command.
Stopping the HDLM Manager
To stop the HDLM manager, log in to Linux as a user with root permissions,
and then execute the following command:
HDLM Operation
4-23
Hitachi Dynamic Link Manager User Guide for Linux ®