Configuring fcip routes – HP IP Distance Gateway User Manual
Page 41
Configuring FCIP routes
Follow these steps to configure the mpx tuning parameters and FCIP routes using the CLI or the
mpx Manager GUI.
Configuring mpx IP tuning parameters using the CLI or GUI
See
IP performance tuning (page 25)
for information on the required configuration settings.
For each mpx110 FCIP route, configure the following tuning parameters:
•
Bandwidth per route setting
•
Software compression
•
TCP window size/scaling
NOTE:
The mpx110 integrates a software compression option. Enable compression for IP fabrics
with an RTT greater than or equal to 50 ms, or guaranteed WAN bandwidth of less than or equal
to 45 Mb/s. See
IP performance tuning (page 25)
for link speed and delay information.
NOTE:
With the exception of the tuning parameters listed above, HP strongly recommends that
you use the default mpx110 settings shown in
.
Configuring the FCIP routes using the CLI
For each mpx110, configure the FCIP route information as shown in
Figure 20 Setting FCIP route using the CLI
Configuring FCIP routes
41