HP IP Distance Gateway - Manual (Page 64)

Figure 39 SNMP Management tab
FCIP routes
The FCIP routes tab Figure 40 (page 66) consists of two sections: FCIP Route Information and
Statistics.
FCIP Route Info tab settings (page 64) provides a definition for each setting.
NOTE: Selecting the FCIP Routes branch on the System tree does not provide any information in
the right window.
FCIP Route Info tab settings
•
FCIP Interface Status—Provides a dialog box for enabling and disabling the FCIP route. When
the route is disabled the FC and GE ports are placed in a down state, but all route configuration
parameters are retained. When you change this setting, you must click Save (at the bottom
of the tab) for the change to take effect.
•
FC Port—Identifies the FC port used for this FCIP route. The FC port cannot be changed because
it is selected when the route is created.
•
FC Link Status—Provides the state of the FC port used in this FCIP route.
•
GigE Port—Identifies the GigE port used for this FCIP route. The GigE port cannot be changed
because it is selected when the route is created.
•
GigE Link Status—Provides the state of the GigE port used in this FCIP route.
NOTE: Change to the following settings do not take effect until you click Save at the bottom
of the page.
•
Local IP Address—The IP address to be used by the GigE port. An uninitialized port has an
IP address of all zeros.
•
Remote IP Address—The IP address of the GigE port on the remote router.
•
Subnet Mask—The subnet mask used by the GigE port.
•
Gateway IP Address—The gateway IP address used by the GigE port.
64 Using the HP mpx Manager utility