HP StorageWorks XP Remote Web Console Software - Manual (Page 72)

Installing Version 2
This section describes how to install Version 2. The installation steps are different depending on
whether Version 1 is installed. Note that you do not need to complete step 2 and step 3 if you do
not have Version 1 installed.
To install Version 2:
1. Check whether there is a need to install additional shared memory or not.
For details, contact your HP service representative.
2. Withdraw all the relationships to delete Version 1 relationships.
Use Remote Web Console or the host command to select and delete all the settings that use
Version 1.
3. Check that all the Version 1 relationships are deleted.
You can use Remote Web Console or the FCQUERY command to check if all the Version 1
relationships are deleted. For details about the FCQUERY command, see
(page 122) .
4. Set all the devices to be used with Version 2 to offline.
5. Enter the license key for Compatible FlashCopy in the Remote Web Console window.
6. Click Apply in the Remote Web Console window.
7. Set all the devices to be used with Version 2 to online.
8. Execute the devserv command with the VALIDATE option of QDASD to the devices in the
storage system.
(page 72) shows an example of the devserv command.
Figure 39 Example of the devserv Command
devserv QDASD, 4200, VALIDATE
By executing this command, you will be able to view the information for the direct access memory
device 4200 and the magnetic disk controller (DASD). Based on the displayed information, update
the information for the expanded functions maintained in the storage of the host processor. By
these operations, the host recognizes that Version 2 is supported.
1. Establish Version 2 relationships.
2. Check that all the Version 2 relationships you wanted to create are created.
You can use Remote Web Console or the FCQUERY command to check if all the Version 2
relationships are created. For details about the FCQUERY command, see
(page 122) .
If any Version 1 relationships remain, you cannot uninstall Version 1 features and software.
In this case, even if you install Version 2, its features will not be available, and the features
of Version 1 will be performed. To use the features of Version 2, make sure that you delete
all the Version 1 relationships.
Even if the license is expired, if any Version 1 relationship remains, Version 1 will be performed
instead of Version 2. To use the features of Version 2, make sure that you delete all Version
1 relationships. Even when the Version 1 license is expired, you can still delete the Version 1
relationships.
Uninstalling Version 2
This section describes how to uninstall Version 2.
To uninstall Version 2:
72 Preparing for Version 2 Operations