HP StorageWorks XP Remote Web Console Software - Manual (Page 85)

Table 50 Parameters for the FCESTABL Command (Version 2/Volume Copying) (continued)
Description Value Parameter
NO is the default setting.
Specifies the device number (device
address) of the T-VOL on which you YES TGTUCB
want to perform the FCESTABL
command. To specify this number, use
the TDEVN parameter.
YES is the default setting.
Specifies the serial number, the CU
number, and the LDEV number of the NO
T-VOL on which you want to perform
the FCESTABL command. To specify
this number, use the TARGET parameter
instead of TDEVN.
Specifies the serial number, the CU
number, and the LDEV number of the Serial number, CU number, LDEV
number of the T-VOL TARGET
T-VOL on which you want to perform
the FCESTABL command.
Use this parameter when TGTUCB is
NO.
Uses the Remote FlashCopy function to
establish a relationship. YES REMOTE
Does not use the Remote FlashCopy
function. NO
NO is the default setting.
Specifies the TrueCopy for Mainframe
source device number (device address). TrueCopy for Mainframe source
device number DEVIN
Use this parameter when REMOTE is
YES.
Specifies the serial number, the CU
number, and the LDEV number of the Serial number, CU number, LDEV
number of the S-VOL SOURCE
S-VOL on which you want to perform
the FCESTABL command.
Use this parameter when REMOTE is
YES.
Specifies the SSID of the CU on which
you establish the FlashCopy
relationship. SSID SSID
Use this parameter when REMOTE is
YES.
Suspends the write operations from the
host to all the S-VOL. FREEZE ACTION
Only the copied part from the S-VOL to
the T-VOL of the established relationship FRR
will be copied. This command reverses
the S-VOL and the T-VOL of the
relationship. See
(page 103) .
Establish the relationship without using
the Preserve Mirror FlashCopy function. NO PRESERVEMIRROR or PRESMIR
If PRESERVEMIRROR is not specified,
NO is set by default.
Establishing Version 2 Relationships 85