HP StorageWorks XP Remote Web Console Software - Manual (Page 92)

Table 52 Parameters for the ICKDSF Command (Version 2/Volume Copying) (continued)
Description Value Parameter Command
completed. If you specify
NO, or nothing, for
CHANGERECORDING,
the relationship will be
withdrawn after the
copying operation is
completed.
The T-VOL can be set to
online after the relationship
is established. YES TGTCANCOMEONLINE or
TGTONLINE
The default setting of this
parameter is YES.
The T-VOL cannot be set to
online until the relationship
is deleted. NO
To be specified when the
Version 2 T-VOL and the YES TGTOKASPPRCPRIM
TrueCopy for Mainframe
M-VOL are shared.
To be specified when the
Version 2 T-VOL and the NO
TrueCopy for Mainframe
M-VOL (or Universal
Replicator for Mainframe
P-VOL) are not shared.
NO is the default setting.
Specifies the CU number, the
LDEV number, or the device CU number
LDEV number
SOURCEVOL or SRCVOL
number of the S-VOL when
Source device number
you use the Remote
FlashCopy function.
Establish the relationship
using the Preserve Mirror REQUIRED PRESERVEMIRROR or
PRESMIR
FlashCopy function. If the
relationship cannot be
established using the
Preserve Mirror FlashCopy
function, the command is
rejected.
TGTOKASPPRCPRIM(YES)
must be specified at the
same time.
Establish the relationship
using the Preserve Mirror PREFERRED
FlashCopy function. If the
relationship cannot be
established using the
Preserve Mirror FlashCopy
function, the copy operation
is executed using the existing
FlashCopy-to-PPRC Primary
Volume function.
92 Performing Version 2 Operations