HP XP P9500 Storage - Manual (Page 173)

Restrictions
•
You cannot define an LU path to volumes reserved by Auto LUN. For more information on
Auto LUN, contact HP Technical Support.
•
You cannot define an LU path to journal volumes.
•
You cannot define an LU path to pool volumes.
•
You cannot define an LU path to system disk volumes.
•
When defining LU paths, you must not use RAID Manager and Remote Web Console at the
same time.
Guidelines
•
If you attempt to apply many settings in the LUN Manager windows, the SVP might be unable
to continue processing. Therefore, you should make nor more than approximately 1,000
settings. Note that many settings are likely to be made when defining alternate paths (see
“Defining alternate LU paths” (page 187) ), even though only two commands are required for
defining alternate paths.
•
Do not perform the following when host I/O is in progress and hosts are in reserved status
(mounted):
◦ Remove LU paths (see “Deleting LU paths” (page 188) )
◦ Disable LUN security on a port (see “Disabling LUN security on a port” (page 192) )
◦ Change the data transfer speed for Fibre channel ports
◦ Change AL-PAs or loop IDs
◦ Change settings of fabric switches
◦ Change the topology
◦ Change the host modes
◦ Remove host groups
◦ Setting command devices
Managing logical units workflow
1. Configure fibre channel ports
2. Configure hosts
3. Configure LU paths
4. Enable LUN security
5. Set fibre channel authentication
6. Manage hosts
Configuring hosts and fibre channel ports
When provisioning your system, configure hosts and fibre channel ports using LUN Manager. You
can manage hosts, modify the host configuration, and modify the port configuration when the
system is in operation.
•
“Configuring fibre channel ports” (page 174)
•
“Configuring hosts” (page 177)
Managing logical units workflow 173