HP Systems Insight Manager - Manual (Page 153)

5. Be sure the primary DNS suffix is set correctly. If not, set it, and click OK until all dialog
boxes are closed.
•
The proxy settings on the client browser is configured to proxy local systems.
HP recommends the following workaround:
1.
In Internet Explorer, select Tools
→Internet Options→Connections→LAN Settings and then
select Use a proxy server for your LAN.
2. Click Advanced.
3. Add the DNS suffix for the CMS to the Exceptions list.
4. Click OK until all dialog boxes are closed.
•
The company DNS servers could be having problems.
HP recommends that you contact your company's network support group.
Complex
You cannot delete a complex and all associated systems when you first select either the system or
complex alone and then try to delete.
Solution: You must select all associated systems from the list for the deletion to work correctly.
Configure or Repair Agents
Configure or Repair Agents cannot be used to install the WBEM Providers to Integrity Windows
systems.
You must manually install the WBEM provider by copying cp010621.exe (can be found in the
smartcomponents directory under the Systems Insight Manager install) to the target system and
then running it.
-------------------------------------------------------------
HP-UX 11.31 does not ship with smbclient, therefore, any Configure or Repair Agents task from
an HP-UX 11.31 CMS to a Windows target fails until smbclient is installed on the CMS.
Solution: A back up smbclient is located under /opt/mx/bin/smbclient. Copy this to the
opt/samba/bin/smbclient
folder to execute the Configure or Repair Agents task.
-------------------------------------------------------------
How do I push an SSH key using mxagentconfig to a target system running Windows Vista?
Solution: HP recommends turning off the Windows Vista User Account Control.
How do I push an SSH key through Configure or Repair Agents on Windows 2008?
Solution: HP recommends disabling User Account Control on Windows 2008 systems.
NOTE: Configure or Repair Agents is not supported on Windows Vista.
-------------------------------------------------------------
I received a connection failed error in Configure or Repair Agents on Windows XP.
Solution: You might have Windows XP SP2 or later installed. Windows XP SP2 disables admin
share. You must enable admin share by using the command net share admin$.
Container View
When the SNMP protocol is disabled and the WBEM protocol is enabled, the HP Integrated
Lights-Out (iLO) firmware version is displayed as Not Available in tool tip of the Picture View.
Solution: To view the iLO firmware version, enable the SNMP protocol. To do so, select
Options
→Protocol Settings→Global Protocol Settings.
Solution: This can happen when the enclosure contains at least one double dense blade (BL2x220c
or ProLiant xw2x220c Blade Workstation) and all the slots in the enclosure are populated with the
Complex 153