HP LaserJet Print to Mail Accessories - Manual (Page 35)

EN Jams 33
7 Close the top cover.
8 Check the fold-chutes to make sure that they are clear of media
and that the correct settings are still in place.
9 Replace both fold-chutes and the output bin.
10 Press the power switch to the “on” (“I”) position.
Note Depending on the nature of the accessory jam, the printer might stop
immediately. If it does, a jam condition might have occurred in the
printer. The paper path jam in the printer must be cleared before
operation can resume.
Resetting the accessory
After clearing a jam, reset the accessory using one of the three
methods shown below:

Remove and reinstall the upper fold-chute.

Remove and reinstall the output bin.

Set the accessory power switch to “standby” (“ ”), and then back
to the “on” (“I”) position.
Jam recovery
After a jam is cleared, when jam recovery is enabled, the printer
reprints pages that might have jammed. Check the output to see
which pages should be reprinted.
You can prevent this when you print certain items (such as checks) by
disabling jam recovery.
To disable jam recovery
1 Press M ENU until Configuration Menu appears on the printer
control panel display.
2 Press I TEM until Jam Recovery appears on the display.
3 Press V ALUE until Jam Recovery = Off appears on the display.
4 Press S ELECT and then press G O .