HP Officejet 5605 All-in-One Printer User Manual
Page 103
The fax test failed
If you ran a fax test and the test failed, review the report for basic information about
the error. For more detailed information, check the report to see which part of the test
failed, and then review the appropriate topic in this section for solutions to try.
●
The "Fax Hardware Test" failed
●
The "Fax Connected to Active Telephone Wall Jack" test failed
●
The "Phone Cord Connected to Correct Port on Fax" test failed
●
The "Using Correct Type of Phone Cord with Fax" test failed
●
The "Dial Tone Detection" test failed
●
The "Fax Line Condition" test failed
The "Fax Hardware Test" failed
Solution
●
Turn off the HP All-in-One by using the
On
button located on the control
panel and then unplug the power cord from the back of the HP All-in-One.
After a few seconds, plug the power cord back in and turn the power on. Run
the test again. If the test fails again, continue reviewing the troubleshooting
information in this section.
●
Try to send or receive a test fax. If you can send or receive a fax
successfully, there might not be a problem.
●
If you have a Windows computer and are running the test from the
Fax
Setup Wizard
, make sure the HP All-in-One is not busy completing another
task, such as receiving a fax or making a copy. Check the control panel
display for a message indicating that the HP All-in-One is busy. If it is busy,
wait until it is finished and in the idle state, before running the test.
After you resolve any problems found, run the fax test again to make sure it
passes and your HP All-in-One is ready for faxing. If the
Fax Hardware Test
continues to fail and you experience problems faxing, contact HP Support. Go to
. If prompted, choose your country/region, and then click
Contact HP
for information on calling for technical support.
The "Fax Connected to Active Telephone Wall Jack" test failed
Solution
●
Check the connection between the telephone wall jack and the HP All-in-One
to make sure the phone cord is secure.
●
Make sure you use the phone cord that came with your HP All-in-One. If you
do not use the supplied phone cord to connect from the telephone wall jack
to your HP All-in-One, you might not be able to send or receive faxes. After
you plug in the phone cord that came with your HP All-in-One, run the fax
test again.
●
Make sure you have correctly connected the HP All-in-One to the telephone
wall jack. Using the phone cord supplied in the box with your HP All-in-One,
connect one end to your telephone wall jack, then connect the other end to
Chapter 11
100
HP Officejet 5600 All-in-One series
Troubleshooting