HP Officejet 5605 All-in-One Printer - Manual (Page 22)

software. After you run the Fax Setup Wizard (Windows) or Fax Setup Utility
(Mac), follow the procedures in this section to complete your fax setup.
Set up the HP All-in-One for faxing
Before you begin setting up your HP All-in-One for faxing, determine which kind of
phone system your country/region uses. The instructions for setting up your HP All-in-
One for faxing differ depending on whether you have a serial- or parallel-type phone
system.
●
If you do not see your country/region listed in the table below, you probably have
a serial-type phone system. In a serial-type phone system, the connector type on
your shared telephone equipment (modems, phones, and answering machines)
does not allow a physical connection to the "2-EXT" port on your HP All-in-One.
Instead, all equipment must be connected at the telephone wall jack.
● If your country/region is listed in the table below, you probably have a parallel-
type telephone system. In a parallel-type phone system, you are able to connect
shared telephone equipment to the phone line by using the "2-EXT" port on the
back of the HP All-in-One.
Note If you have a parallel-type phone system, HP recommends you use
the 2-wire phone cord supplied with your HP All-in-One to connect the
HP All-in-One to the telephone wall jack.
Countries/regions with a parallel-type phone system
Argentina Australia Brazil
Canada Chile China
Colombia Greece India
Indonesia Ireland Japan
Korea Latin America Malaysia
Mexico Philippines Poland
Portugal Russia Saudi Arabia
Singapore Spain Taiwan
Thailand USA Venezuela
Vietnam
If you are unsure which kind of telephone system you have (serial or parallel), check
with your telephone company.
Choose the right fax setup for your home or office
To fax successfully, you need to know what types of equipment and services (if any)
share the same phone line with your HP All-in-One. This is important because you
might need to connect some of your existing office equipment directly to your HP All-
User Guide 19
Finish
setup