HP Officejet 5605 All-in-One Printer - Manual (Page 126)

4. Place the print cartridges in print cartridge protectors or an airtight plastic container so they
will not dry out, and put them aside. Do not send them with the HP All-in-One unless the
HP customer support call agent instructs you to.
5. Close the print-carriage access door and wait a few minutes for the print carriage to move
back to its home position (on the left side).
Note Make sure the scanner has returned to its parked position before turning off
the HP All-in-One.
6. Press the On button to turn off the HP All-in-One.
Remove the control panel faceplate
Complete the following steps once you have removed the print cartridges and unplugged the
HP All-in-One.
Caution 1 The HP All-in-One must be unplugged before following these steps.
Caution 2 The replacement HP All-in-One will not be shipped with a power cord. Store
the power cord in a safe place until the replacement HP All-in-One arrives.
1. Press the On button to turn off the HP All-in-One.
2. Unplug the power cord, and then disconnect it from the HP All-in-One. Do not return the
power cord with the HP All-in-One.
3. Remove the control panel faceplate as follows:
a.
Place your hands on each side of the control panel faceplate.
b. Use your fingertips to pry the control panel faceplate off.
4. Retain the control panel faceplate. Do not return the control panel faceplate with the HP All-
in-One.
Caution The replacement HP All-in-One might not come with a control panel
faceplate. Store your control panel faceplate in a safe place, and when the
replacement HP All-in-One arrives, reattach your control panel faceplate. You must
attach your control panel faceplate to use the control panel functions on the
replacement HP All-in-One.
Note See the Setup Guide that came with your HP All-in-One for instructions on
how to attach your control panel faceplate. The replacement HP All-in-One might
come with instructions for setting up your device.
User Guide 123
HP w
arranty
and
support