HP Officejet 5605 All-in-One Printer - Manual (Page 49)

Load paper
This section describes the procedure for loading different types and sizes of paper
into your HP All-in-One for your copies, printouts, or faxes.
Tip To help prevent rips, wrinkles, and curled or bent edges, store all paper
flat in a resealable bag. If the paper is not stored properly, extreme changes in
temperature and humidity might result in curled paper that does not work well
in the HP All-in-One.
Load full-size paper
You can load many types of letter, A4, or legal paper into the input tray of your HP All-
in-One.
To load full-size paper
1.
Remove the output tray and slide the paper-width guide to its outermost position.
2. Tap a stack of paper on a flat surface to align the edges, and then check the
paper for the following:
–
Make sure it is free of rips, dust, wrinkles, and curled or bent edges.
– Make sure all the paper in the stack is the same size and type.
3. Insert the stack of paper into the input tray with the short edge forward and the
print side down. Slide the stack of paper forward until it stops.
Caution Make sure that the HP All-in-One is idle and silent when you
load paper into the input tray. If the HP All-in-One is servicing the print
cartridges or otherwise engaged in a task, the paper stop inside the
device might not be in place. You could push the paper too far forward,
causing the HP All-in-One to eject blank pages.
Chapter 4
46 HP Officejet 5600 All-in-One series
Load
originals
and
load
paper