Sper Scientific 850037 Large Display Conductivity Pen - Manual (Page 25)

25
Temperature Units (tUt)
To select the Celsius or Fahrenheit
temperature scale:
1. Press
SET for 2 seconds to enter setup.
2. “t” will appear on the primary display of
the LCD and “P1.0” will appear on the
secondary display.
3. Press SET again for less than one
second to enter the unit setting.
4. Press ▲ or ▼ to select C (Celsius) or
F (Fahrenheit). Press SET for less than
one second to confirm the unit selection.
Press SET for more than 2 seconds to
return to P1.0 without saving.
5. After confirming the temperature unit
selection, you may continue to set other
temperature related parameters by
pressing SET for more than 2 seconds
to return to P1.0.
6. When in P1.0, press SET for more
than 2 seconds to return to
Measurement Mode.