Sper Scientific 850037 Large Display Conductivity Pen - Manual (Page 28)

28
Resetting the Pen (rSt)
When the pen is reset, all parameters
(including calibration information) will be
reset to factory default values.
1. Press SET for 2 seconds to enter setup.
2. Press ▲ to select the reset pen setting.
“rst” will appear on the main display of
the LCD and “P3.0” will appear on the
secondary display.
3. Press SET again for less than one
second to enter the reset setting.
4. Press ▲ to select Y (yes) or N (no).
5. Press SET for less than one second to
confirm the selection or press SET for
more than 2 seconds to return to P3.0
without saving.
P2.0: TDS factor setting: (tdS,8361 only)
P2.1: S etting TDS factor(tds):
In P2.0, press " " momentarily to
enter P2.1. (P2.1 will not display on
LCD). The factor will flash on LCD.
Press " " or " " to change factor
from 0.40 to 1.00. Press " " momen-
tarily to confirm the value and meter
will return to P2.0. Or pressing " "
more than 2 seconds to return to
P2. 0 without confirming the value.
P3.0: Reset meter: (rSt)
In P2.0, press " " or " " to enter P3.0.
When you decide to reset the meter, all
parameters will be reset to factor default
values include the calibration info.
NOTE:
Pay attention
to the diffe-
rence between
short or long
press " "
after setting
the tds value.
10
In P1.0, press " " to select P2.0.
P3.1: Reset
In P3.0, press " " momentarily to
enter P3.1. Press " " or " "to select
Y or N. Press " " momentarily to
confirm the state and return to P3.0.
Or press " " more than 2 seconds
to return to P3. 0 without confirming
the P3.1 value.