Vaisala HMP260 - Manual (Page 35)

HMP260 SERIES
HMP260-U017en-1.5 Operating Manual
1997-11-25 29
5.3.6.1 Setting the serial interface operation mode
• Select Mode in the main menu; the following is displayed:
• Select Serial output:
• The currently valid setting flashes. Select the desired mode with the
arrow keys and press ENT. After this the programme returns to the
Mode Menu.
• When Run mode is selected, the currently valid output interval is dis-
played:
The output interval setting can be changed as follows:
• press CL
• the number starts flashing
• if the interval needs to be changed, press CL again and enter the new
interval; otherwise press ENT
• the unit (seconds or hours) starts flashing
• the unit can be changed with the arrow keys and acknowledged with
ENT
• after this the programme returns to Mode menu
5.3.7 Others
5.3.7.1 Setting the measurement integration time
By lengthening the measurement integration time any stray changes in the out-
put can be filtered out: the transmitter calculates the average of a number of
measurement cycles defined by the user.