Vaisala MMT330 - Manual (Page 84)

User's Guide _______________________________________________________________________
84 ___________________________________________________________________ M210764EN-F
Using Serial Line
Use the serial line command NET to view or set the network settings for
the LAN and WLAN interfaces. You can also refresh the network
information or disconnect all active connections.
NET [REFRESH] [DISCONNECT] [DHCP WEB] [DHCP IP SUBNET
GATEWAY WEB]<cr>
where
REFRESH = Updates the network information and displays it
DISCONNECT = Disconnects all current sessions
DHCP = ON or OFF. Enables or disables the automatic IP
configuration.
WEB = ON or OFF. Enables or disables the Web
Configuration page.
IP = The four part network ID of the transmitter. Must
be set manually if automatic configuration is not
used.
SUBNET = Used together with the IP address to determine
which network the transmitter is a part of. Must be
set manually if automatic configuration is not used.
GATEWAY = IP address of the server that enables the transmitter
to access other networks. Must be set manually if
automatic configuration is not used.
Examples:
>net refresh
OK
DHCP : OFF
IP address : 192.168.0.101
Subnet mask : 255.255.255.0
Default gateway: 192.168.0.1
Web config. : OFF
MAC address : 00:40:9d:2c:d2:05
Status : Not connected
>
>net on off
DHCP : ON
IP address : 192.168.0.104
Subnet mask : 255.255.255.0
Default gateway: 192.168.0.1
Web config. : OFF
MAC address : 00:40:9d:2c:d2:05
Status : Connected
OK
>