Kenwood TM-D710GA - Manual (Page 10)

2
MOBILE INSTALLATION
■ TX/ RX Unit Installation
Select a safe, convenient location inside your vehicle that will minimize danger
to your passengers and yourself while the vehicle is in motion. Consider
installing the transceiver under the dash in front of the passenger seat so that
knees or legs will not strike the radio during sudden braking of your vehicle.
Try to a pick well-ventilated location that is shielded from direct sunlight.
Note: You may experience interference on the GPS receiver when using in or around
438.8 MHz (A band) and/or 443.8 MHz (B band). To eliminate the interference, ensure that the
TX/RX unit is installed at a location separate from the Operation Panel.
1 Install the mounting bracket in the vehicle using the supplied self-tapping
screws and fl at washers (4 of each are supplied).
• The bracket can be mounted with the bracket opening facing down, for under
dash mounting, or facing up.
• The bracket must be installed so that the 3 screw slots on the edge of each
bracket side are facing the back.
2 Position the transceiver, then insert and tighten the supplied hexagon
SEMS screws and fl at washers (4 of each are supplied, 2 for each side of
the bracket).
• Ensure that all hardware is tightened, to prevent vehicle vibration from
loosening the bracket or TX/ RX unit.
• Set an appropriate angle for the TX/ RX unit, using the 3 screw slots on
the rear edge of each bracket side.
Self-tapping screw
(5 x 16 mm)
Flat washer
SEMS screw (M4 x 10 mm)