Kenwood TM-D710GA - Manual (Page 14)

6
REPLACING FUSES
If the fuse blows, determine the cause, then correct the problem. After the
problem is resolved, replace the fuse. If newly installed fuses continue to blow,
disconnect the power cable and contact your authorized KENWOOD dealer or an
authorized KENWOOD service center for assistance.
Fuse Location Fuse Current Rating
Transceiver
(located on the DC connector)
15 A
Supplied DC power cable 20 A
Only use fuses of the specifi ed type and rating; otherwise the transceiver could be damaged.
Panel jack
MIC jack
Microphone
Operation panel
TX/ RX unit
Fuse
Fuse holder
OPERATION PANEL AND MICROPHONE CONNECTION
Plug the microphone plug into the MIC jack, then connect the Operation panel to
the TX/ RX unit with the supplied cable.
• Attach the microphone hanger to an appropriate position using the screws included in
the screw set.
Modular plug cable
Installing the Line Filter
Install the line fi lters
approximately 3 cm from the
connectors.
Approx. 3 cm
Line fi lter
Line fi lter