Kenwood TM-D710GA - Manual (Page 17)

9
g TONE
Press [TONE] to turn the Tone function ON.
Each time you press [TONE], the function cycles through the following: Tone
ON
➡ CTCSS ON ➡ DCS ON ➡ Cross Tone ON ➡ OFF.
h REV
Press [REV] to turn the Reverse function ON or OFF.
Press [REV] (1s) to turn the Automatic Simplex Checker ON.
i LOW
Press [LOW] to toggle the transmit output power as follows:
Middle Power ➡
Low Power
➡ High Power.
j PF1
Press [PF1] to activate its programmable function. The default function is
“Weather Channel” (TM-D710GA)/“Frequency Band Select” (TM-D710GE).
k PF2
Press [PF2] to activate its programmable function. The default function is
“Operation Band Select”.
l BAND SEL (VOL) Control
Rotate the [BAND SEL] control to adjust the speaker volume.
Press the left [BAND SEL] to select the A band. Press the right [BAND SEL]
to select the B band.
Press [BAND SEL] (1s) to toggle between single and dual-band mode.
m SQL Control
Rotate the [SQL] control to adjust the squelch level. Clockwise tightens the
squelch and counterclockwise opens the squelch.
n TNC
Press [TNC] to turn the built-in TNC ON and the APRS (or NAVITRA) mode
ON.
Each time you press [TNC], the mode toggles as follows:
APRS (or NAVITRA) mode ON
➡ PACKET mode ON ➡ TNC OFF.
• When the built-in TNC turns on, “OPENING TNC” appears on the display.
• When “OPENING TNC” appears on the display, the mode cannot be changed.
o PM
Press [PM] to enter the PM (Programmable Memory) channel selection mode.
p
Press [ ] to turn the transceiver power ON and OFF.