Kenwood TM-D710GA - Manual (Page 6)

ii
PRECAUTIONS
Observe the following precautions to prevent fi re, personal injury, and transceiver
damage.
• When operating mobile, do not attempt to confi gure the transceiver while driving; it is too
dangerous.
• Do not transmit with high output power for extended periods. The transceiver may
overheat.
• Do not disassemble or modify the transceiver for any reason, unless instructed by this
manual or by KENWOOD documentation.
• Do not expose the transceiver to long periods of direct sunlight, nor place it near heating
appliances.
• Do not place the transceiver in excessively dusty, humid, or wet areas, nor on unstable
surfaces.
• If an abnormal odor or smoke is detected coming from the transceiver, switch the
transceiver power off immediately, and contact a KENWOOD service station or your
dealer.
• Use of the transceiver while you are driving may be against traffi c laws. Please check
and observe the vehicle regulations in your area.
• Do not use options not specifi ed by KENWOOD.
◆ The transceiver is designed for a 13.8 V DC (±15%) power source! Never use a 24 V battery to
power the transceiver. Check the battery polarity and voltage of the vehicle before installing the
transceiver.
◆ Use only the supplied DC power cable or a KENWOOD optional DC power cable.
◆ Do not insert metal objects into the cooling fan.
◆ Do not cut and/or remove the fuse holder on the DC power cable. Improper connections and/or
current surges may cause smoke or fi re.
◆ For passenger safety, install the transceiver securely using the supplied mounting bracket and
screw set so the transceiver will not break loose in the event of a collision.
◆ Various electronic equipment in your vehicle may malfunction if they are not properly protected
from the radio frequency energy which is present while transmitting. Electronic fuel injection,
anti-skid braking, and cruise control systems are typical examples of equipment that may
malfunction. If your vehicle contains such equipment, consult the dealer for the make of vehicle
and enlist his/her aid in determining if they will perform normally while transmitting.