Kenwood TM-D710GA - Manual (Page 18)

10
■ In Function Mode
a C.IN
Press [C.IN] to store the current operating frequency to the Call channel.
b M>V
Press [M>V] to copy the current Memory channel or Call channel to the VFO
(memory shift).
c M.IN
Select a Memory channel, then press [M.IN] to store the current operating
frequency in the Memory channel.
d Tuning Control
Press the Tuning control to enter Menu mode.
e F OFF
Press [F OFF] to return Normal mode.
f T.SEL
While Tone, CTCSS, DCS, or Cross Tone is ON, press [T.SEL] to enter Tone,
CTCSS, DCS, or Cross Tone setup mode.
g SHIFT
Press [SHIFT] to enter Offset Direction selection mode. Each time you press
[SHIFT], the offset direction toggles as follows:
plus (+) direction
➡ minus (–) direction ➡ –7.6 MHz (TM-D710GE only) ➡ OFF.
h MUTE
Press [MUTE] to turn the Mute function ON or OFF.
i VISUAL
Press [VISUAL] to turn the Visual Scan function ON and OFF.
j BAND SEL (VOL) Control
Rotate the [BAND SEL] control to adjust the speaker volume.
Press [BAND SEL] to select a frequency band.