Kenwood TM-D710GA - Manual (Page 23)

15
TX/ RX UNIT REAR PANEL
a ANT
Connect an SO-239/M-type (TM-D710GA) or N-type (TM-D710GE) external
antenna to this terminal. When making test transmissions, connect a dummy
load in place of the antenna. The antenna system or load should have an
impedance of 50
.
b DATA
This is the data input/output terminal. Use a PG-5H (option) data
communications cable when connecting to the PC voice input/output terminal.
c PC
This terminal is for connecting to a PC. Use a PG-5G (option) cable or a
PG-5H (option) serial communications cable when connecting to a computer
D-SUB terminal.
d SP (SP 1/ SP 2)
If desired, connect 1 or 2 external speakers for clearer audio. These jacks
accept 3.5 mm (1/8") diameter, 2-conductor plugs.
TX/ RX UNIT SUB PANEL
a MIC
Connect the supplied microphone to this jack.
b PANEL
Connect the Operation panel to this jack using the supplied Modular plug
cable.