Videotec SM328B - Manual (Page 38)

Select Accepted values/Cameras and enable the cameras according to the installation as shown in
the table and then select Accepted values/local Monitor-Mux and enable the monitors properly.
System Enabled input (Cameras) Enabled output (Monitors)
Parallel matrix 2 (2 matrixes) 1..32, 101..132, 201..232 1..8
Parallel matrix 2 (3 matrixes) 1..32, 101..132, 201..232, 301..332 1..8
Parallel matrix 2 (9 matrixes) 1..32, 101..132, 201..232, ... , 901..932 1..8
Master matrix 2 (1 slave) 1..32, 101..132 1..8
Master matrix 2 (2 slaves) 1..32, 101..132, 201..232 1..8
Master matrix 2 (3 slaves) 1..32, 101..132, 201..232, 301..332 1..8
Master matrix 2 (4 slaves) 1..32, 101..132, 201..232, 301..332, 401..432 1..8
Slave matrix 2 1..32 1..4
Telemetry settings:
Telemetry on keyboard lines A and B
The keyboard will decode from the logical to the physical address (for example camera 5 could have the
physical address 23).
On the keyboard select Communications/Telemetry and set the parameter Logical address to
NO.
Telemetry on keyboard video line
• The matrix will decode from the logical to the physical address
Set up the matrix to decode from the physical to the logical address.
On the keyboard select Communications/Telemetry and set the parameter Logical address to
YES.
• The keyboard will decode from the logical to the physical address
Set up the matrix so that it will not decode from the physical to the logical address.
On the keyboard select Communications/Telemetry and set the parameter Logical address to
NO.
• 7. Appendix 2: composite installations Page 36/65 MNVCSM328A_0438