Videotec SM328B - Manual (Page 67)

8.3.17 Final window
At this point all the parameters have been configured. It is therefore possible to modify some of the
configurations by going backwards through the program. By clicking on the “<< Back” key it is in fact
possible to scroll back through the previous screens.
Once the optimal configuration has been established it is possible
1. to transmit the data matrix
2. save the configuration file.
So that the matrix can be configured according to the parameters specified in the file it is necessary to
transmit the data to the matrix itself, simply saving the file does not mean that the data is transmitted.
It is thus possible to delay the configuration of the matrix: in this case the file can be saved by and the
transmission of the data can be put off until another time.
To transmit the data to the matrix, click on the “Send data to matrix” button. (This operation can also be
performed from the File>Send to matrix menu or from the tool bar).
To save the file click on the “Save current configuration” button. (This operation can also be performed
from the File>Save menu or from the tool bar).
To exit click on the “Exit” button. (This operation can also be performed from the File>Exit menu or from
the tool bar). attention, if the program is exited before the settings are saved, they will be lost.
The data transmission to matrix, file save and program exit operations can anyway be implemented from
the main menu at all times the file is being prepared.
• 8. Configuration software Page 65/65 MNVCSM328A_0438
figure 23: final window
Send data to
matrix button
Save
configuration
button
Exit the
program button