Campbell Scientific CR3000 Micrologger - Manual (Page 363)

Section 8. Operation
363
Figure 114: Configuration and wiring of PakBus LAN
8.5.6.2 LAN Setup
Configure CR3000s before connecting them to the LAN:
1. Start Device Configuration Utility (DevConfig). Click on Device Type:
CR3000. Follow on-screen instructions to power CR3000s and connect them
to the PC. Close other programs that may be using the PC COM port, such as
LoggerNet, PC400, PC200W, HotSync, etc.
2. Click on the Connect button at the lower left.
3. Set CR3000 settings using DevConfig as outlined in table PakBus-LAN
Example Datalogger-Communications Settings
(p. 365).
Leave unspecified
settings at default values. Example DevConfig screen captures are shown in
figure DevConfig Deployment | Datalogger Tab
(p. 364)
through figure
DevConfig Deployment | Advanced Tab
(p. 365).
If the CR3000s are not new,
upgrading the operating system or setting factory defaults before working this
example is advised.