Campbell Scientific T.Weather T107 Toro Weather Station - Manual (Page 28)

T107 Weather Station
FIGURE 2-10. Temperature/Relative Humidity Sensor without Yellow
Protective Cap
3. Insert the temperature/relative humidity into the gill radiation shield until
it stops.
4. Attach the gill radiation shield to the underside of the crossarm using the
two knurled thumb screws from step 1.
2.4.4 034B Wind Sensor (Wind Sensor Option –MW)
1. Install the 034B Wind Sensor as shown in FIGURE 2-11 after the sensor
arm is securely installed.
Plugging this sensor into the connector marked “SDI
12” can result in damaging this sensor, the main
enclosure connector board, or both.
WARNING
Temperature and
RH Sensor
without Cap
20