2 phone modem, 1 internal installation, Phone modem – Campbell Scientific T.Weather T107 Toro Weather Station User Manual
Page 40: Internal installation
T107 Weather Station
2.5.2 Phone Modem
Phone modems enable communications between the ET Enclosure and a Hayes
compatible modem at your PC over a dedicated phone line. Phone line surge
protection is built into the ET Enclosure. By default, the COM220 phone
modem is configured for SDC7.
FIGURE 2-24. Phone Modem Mounting and Connections (battery not
shown)
2.5.2.1 Internal Installation
If the phone modem was ordered with the T107, you can skip this
section and go directly to Section 2.5.2.2, External Installation.
For installation inside the ET Enclosure, the following components are
provided in the phone modem kit:
(1) COM220 Phone Modem
(1) 12 inch RJ-11 Patch Cord
(1) Mounting Bracket
(4) Screws
(1) 12 inch 14 AWG Ground Wire
Install the phone modem as shown in FIGURE 2-24.
1. Attach the modem to the modem bracket with the 2 screws provided.
Mount the modem and bracket into the ET Enclosure with the 3 pre-
threaded screws on the mounting plate.
NOTE
RJ-11 Patch Cord Connects with RJ-11 Jack
10588 Ribbon Cable
Ground Wire
32