8 sensor connections, Sensor connections, 21. position of sensor bulkhead connectors – Campbell Scientific T.Weather T107 Toro Weather Station User Manual
Page 36
Advertising
T107 Weather Station
2.4.8 Sensor Connections
Sensor schematics are provided in Section 4.3.1, Sensor Schematics.
1. Each sensor cable plug attaches to a unique bulkhead connector as shown
in FIGURE 2-21. The sensor cables are individually marked to match up
with the sensor labeling on the back of the enclosure.
The 034B Wind Sensor plugs into the connector labeled
WS/WD. Plugging this sensor in the connector labeled
SDI-12 may damage the sensor and/or the main
enclosure connector board.
FIGURE 2-21. Position of Sensor Bulkhead Connectors
WARNING
Enclosure Ground Lug
Sensors
TEMP CS616
WS/WD
SDI-12
TEMP/SONIC
RAIN (PRECIP)
TEMP/RH
SOLAR RADIATION
COMM
POWER
BNC Coaxial
Connector
Standoff
Wire Tie Harness
28
Advertising