Allied Telesis AT-UWC Series - Manual (Page 135)

Chapter 3: Switching
135
Reset VLAN Configuration
From the Reset VLAN Configuration page, you can reset the VLAN
configuration to the default settings.
Default VLAN
Settings
Here are the default VLAN settings:
 Only VLAN 1 is on the WLAN Controller, which is the default
VLAN.
 The Port VLAN ID is set to VLAN 1.
 The Acceptable Frame Type on the port is the “Admit All” option.
 The Ingress Filtering on the port is set to “disable.”
 The port sends only untagged frames.
Note
For the descriptions of VLAN port properties, see Table 37 on
page 133
Resetting the
VLAN
Configuration
To reset the VLAN configuration, do the following:
1. From the Navigation pane, go to Switching > VLAN > Reset VLAN
Configuration.
The Reset VLAN Configuration page is displayed as shown in
Figure 77.
Figure 77. Reset VLAN Configuration Page
2. Click Reset.
The Reset VLAN Configuration to Factory Defaults page is displayed.
3. Click Reset.